Nucleus-N Tilta Productions Wireless Follow-Focus

Owned by Jean Bed E

4.87/5

Identified

Usually responds within a few hours

100% response rate

Ardwick 161.3 mi

Film and photography equipment is insured with no excess in the event of damage. Read more

Description

The WLC-T04 motor can only power lens of DSLR and Mirrorless . WLC-T04 motor could not work with any Sigma lens and film lens. The WLC-T04 motor can not power those big lens with large damping. The hand wheel need to be installed at least 30cm from the motor. If install them too close, it could not work.The hand wheel could not be connected to any external power supply. The hand wheel main board will be burn if connect to external power supply. The hand wheel can only be powered by the battery. The Nano Hand Wheel Controller has a compact knob design similar to professional follow focus hand units (the design is very similar to the Tilta Nucleus-M hand unit’s focus wheel). The Nano Hand Wheel Controller has no delay. It is highly responsive, wireless, and accurate. It is powered via a single 14500 rechargeable battery (which is included in the kit) and yields a 6 hour operating time. The Nucleus-Nano uses a brand new state of the art power-efficient miniature motor. The Nano Motor features low noise and high torque. It can perform super fast focus pulls with silent precision! The built-in 15mm rod adapter allows for flexibility and compatibility with a wide range of camera rigs and professional mounting solutions. The Nano Motor has its own built-in motor drive that communicates directly with the Nano Hand Wheel Controller. This negates the need to mount a separate MDR to your rig, allowing for a more compact camera setup and a quicker setup time. Simply set the Nano Motor and Nano Hand Wheel Controller to the same channel and you will have full control. The wireless range of both the Nano Hand Wheel Controller and Nano Motor is 300 feet! The Nano Motor allows for automatic calibration of the lens as well as a manual calibration if you are using lenses that don’t have hard end stops at close focus and infinity via the ability to set A-B limits on the Nano Hand Wheel Controller. Every motor has a 0.8 mod, which is the standard gear size for most cinema lenses. The torque of the Nucleus-Nano Motor at 5.5V is 0.65N·m and at 14.8V is 1N·m.