Indoor audio kit 1 person: 1xSenn radio mic G3+boom+Zoom F4+MKH50

Owned by Stan W

5/5

Identified

Usually responds within a few hours

93% response rate

Hackney Wick 5.1 mi

Damages are covered without any excess. Read more

Description

# rental from 1 day, flexible times, even late notice last minute booking. I have vaste range of an audio gear, for almost any possible scenario, just ask. I´m a sound recordist myself. Please see my profile. This is a great sound kit for 1 person being recorded - typically monologue or one side interview. You will get all you need for nice and clean audio: # Zoom F4 recorder in a big bag + everlasting NP1 lion battery + 32 gb Sd card # 1x Sennheiser G3 radio kit, UK legal frequency + 1x ME2 lavalier microphone + cables # 4AA fully charged Eneloop Pro 2500mAh batteries provided # for rentals 2 or more days intelligent 4AA charger provided free of charge. If you wish to have a alkaline AA batteries as a back-up. I stock high-quality Duracel/Energizer £1/AA # Rode AL boom pole 2.1m/3.3m + Rycote Lyre shockmount # 1pc indoor microphone Sennheiser MKH50 - one of the best, no quality compromise! # AudioTechnika ATH-M50x headphones for monitoring # all necessary cables - 3m XLR cable for boom pole, xlr-3.5mm cable for radio set, USB cable and card reader Please note, the often requested Sennheiser MKH416 IS NOT SUITABLE for interior recordings as you may get bad artefacts. OPTIONAL - send me message: # Boom microphone can be replaced for MKH50, please ask for a cost and availability # Standard microphone ME2 has diameter 6.5mm and sounds just alright, but if you are after proper audio quality or you need to hide a mic, I strongly recommend to upgrade for smaller and higher quality dia 4.8mm Sennheiser MKE2 for just +£5/day or the smallest available lapels Sennheiser MKE1 (3.3mm diameter) or Countryman B6 (only 2.54mm diameter!) for just +£10/day. # wanna move around with boom? Go wireless! Get plugin transmitter Sennheiser SKP500 with phantom power 48V + receiver for just +£10/day # gonna move around with boom all day long? Swap aluminium Rode for light carbon Panamic boom pole and save your muscles for just +£5/day # In need of 100% accurate sync? Rent 1pc of Tentacle Sync TimeCode with cables for all major devices BMPCC, Arri, Red, SD, Zoom for just +£10/day # wanna further improve sound quality or do you expect both silent and very loud signal? Get a SoundDevices MixPre with excelent mic preamps and hardware limiters to avoid clipping. Simply be on the safe side! For just +£10/day # run out of consumables to attach a lapel? I have a good range of common accessorries: Rycote stickies, Rycote undercover, overcover, Ursa foams white, black, skin safe tapes, silicon pads, BubbleBee Cable Savers, elastic bandage with clips IMPORTANT NOTE FOR WIRELESS RADIO: If you are not sure, how to properly set up and use the radios, please watch some youtube videos, there are plenty of them. However before you start, make sure you followed these basic steps: 1. scan available frequencies to avoid any interference and make sure you are within allowed range of frequencies (valid for UK). For E band it is free channel 70: 863-865Mhz and for GB band it is ofcom licensed channel 38: 606-614Mhz. You must be within this range! 2. sync setting with your transmitter - easy with IR based sync, please watch https://www.youtube.com/watch?v=O4k_j-0H5Js 3. set up sensitivity for the transmitter input. This will depend on the type of used microphone and the loudness of the talent. 4. set up your output gain for the receiver (AF out). This will depend on your recorder 5. check the pilot tone and squelch setting according to your needs. 6. test all connections and sound free of interference and any other unwanted sound 7. do not stick any strong sticks or labels, which are difficult to remove or which are leaving residual glue (like some velcro stics) as this is difficult to remove and damages the kit. You will be charged the damage for doing so! Standards setting are: # Squelch as low # pilot tone active (both transmitter and receiver) # transmitter sensitivity -12dB # receiver output gain "AF out" sensitivity 0dB # transmitter cable emulation minimum T&C: # please see my profile # all clients are obliged to get to now my term and conditions use this link to save £20 off from your first rental fatllama.com/r/stan-3fea2