# rental from 1 day, flexible times, even late notice last minute booking. I have vaste range of an audio gear, for almost any possible scenario, just ask. I´m a sound recordist myself. Please see my profile. what you get: Sennheiser EW100 G3 kit: # 3x transmitter + 3x receiver, hotshoe mount+clips # 3x standard ME2 microphone with basic wind protection # operates in UK licence range E and GB # 3x 3.5mm jack to jack cable, 3.5mm to xlr cable # 12AA fully charged Eneloop Pro 2500mAh batterie provided - 4AA for each set # for rentals 2 or more days intelligent 4xAA charger provided free of charge. If you wish to have a alkaline AA batteries as a back-up. I stock high-quality Duracel/Energizer for £1/pc OPTIONAL: # Standard microphone ME2 has diameter 6.5mm and sounds just alright, but if you are after better audio quality or you need a smaller mic, I recommend to upgrade for these: * +£5/day for dia 4.8mm Sennheiser MKE2 or +£10/day for any of these: *Sennheiser MKE1 (3.3mm diameter) *Countryman B6 (only 2.54mm diameter!) *Dpa 4060 # various lapel mounting options like Rycote Stickies, undercover, overcover, 3M Hypoallergenic tape, Ursa foamies, BubbleBee Cable Savers - just ask # plug on transmitter Sennheiser SKP500 with phantom power P48 for your shotgun to go wireless for just +£10/day. IMPORTANT NOTE: If you are not sure, how to properly set up and use the radios, please watch some youtube videos, there are plenty of them. However before you start, make sure you followed these basic steps: 1. scan available frequencies to avoid any interference and make sure you are within allowed range of frequencies (valid for UK). For E band it is free channel 70: 863-865Mhz and for GB band it is ofcom licensed channel 38: 606-614Mhz. You must be within this range! 2. sync setting with your transmitter - easy with IR based sync, please watch https://www.youtube.com/watch?v=O4k_j-0H5Js 3. set up sensitivity for the transmitter input. This will depend on the type of used microphone and the loudness of the talent. 4. set up your output gain for the receiver (AF out). This will depend on your recorder 5. check the pilot tone and squelch setting according to your needs. 6. test all connections and sound free of interference and any other unwanted sound 7. do not stick any strong sticks or labels, which are difficult to remove or which are leaving residual glue (like some velcro stics) as this is difficult to remove and damages the kit. You will be charged the damage for doing so! Standards setting are: # Squelch as low # pilot tone active (both transmitter and receiver) # transmitter sensitivity -12dB # receiver output gain "AF out" sensitivity 0dB # transmitter cable emulation minimum T&C: # please see my profile # all clients are obliged to get to now my term and conditions use this link to save £20 off from your first rental fatllama.com/r/stan-3fea2